|Home About Us Service-Process Flooring Architectural Industrial Photos Contact Us-Links|
GET A QUOTE FROM PERFECT EDGE!
It all starts with a phone call or an email (firstname.lastname@example.org or email@example.com) or a fax (770-458-9595). Send a dimensioned drawing or file to Perfect Edge along with information including:
Please note that Perfect Edge requests that the customer supply materials for all jobs. Should any assistance be required in securing substrate material, please contact Perfect Edge to discuss. Prepayment for material will be required for any substrates purchased by Perfect Edge.
Perfect Edge accepts the following file types, in order of preference:
If extensive drafting is required, an hourly rate will apply.
Perfect Edge will fax or email back a proposal in WORD format. Please refer to the proposal number for future correspondence. Once the quote is accepted, a Purchase Order is required from the customer to confirm the job.
PERFECT EDGE PRODUCTION LEAD TIME
The average lead time is one week. However, large jobs may require additional time. Rush jobs may be completed within 2 days (depending on size) with a 30% of the quoted price surcharge. Perfect Edge does require a minimum charge - please contact sales for more information.
TILE INLAY JOBS
After job approval, tiles should be shipped to Perfect Edge. On arrival of the tiles, a shop drawing will be produced in DWG and PDF formats. The PDF will be submitted to the customer for approval. Production begins after the drawing has been approved. On completion, the inlay is assembled and a digital image produced. The inlay is then disassembled and crated with an installation diagram. A copy of the installation diagram and the digital photo are sent to the customer. For more information, see the flooring inlays page.
PERFECT EDGE CAPABILITIES
Maximum Weight: 10,000 Lbs
Cutting Area: 6 ft by 12 ft. Larger areas may be accommodated with an additional set-up fee.
Maximum Thickness: 8 inches (except carbide and tempered glass.)
Materials which require special setup: glass, acrylic, porcelains, ceramics, certain plastics
Materials that can be cut with the water only head: vinyl, VCT, wood, paper, rubber
Parts at less than 2 inches in size: These must be tabbed to prevent drop out. Tabs can then be broken loose, and the area ground down to clean up the edge. Letters less than 1.5 inches, especially those with a serif font, can not be water-jet cut.
|© 2010-2012 Perfect Edge. 4264 F Winters Chapel Road Doraville, GA 30360 Phone: 770-458-7005 All Rights Reserved. An eFusion Studios Website.|